I had always disturbed me with the distributing and condensing the silage in the end always a small bunch left, which I only got away, by going down from the silo, turning around and in the other direction again. The side effect was that the silo became longer and longer.
On the other hand, I wanted to do something, and so these Fliegl silage labels were made.
What is there now to consider or what is different now:
The small shield has a three-point and a Euro receptacle, which can be used without configuration.
It is intended for smaller companies and driving silos, where there is not so much space available.
The large shield can move more material and therefore has only one shot for the wheel loader. (Teleloder is likely to be submitted in an update)
It is mainly intended for use in BGA’s.
You should take care with this sign something in the traffic, since it has a width of about 4m!
Until everything was still standard and can be used as well.
It is now possible to add small additional labels to the back of the two silage labels, which leads to the silage being “retracted”.
This means that you do not have to go down and down again, but you can distribute the whole silo in one direction and compress it.
In addition, small bumps and holes in the silo can be removed with the rear shield.
The additional signs are located on a pallet in the dismantled state and can be conveniently moved around.
In order to mount it, go with the sign over the pallet (from which side you have to do that, is marked with an “arrow” on the pallet)
Then simply dock.
For more information and how to use the slides, check out the video.
So I wish you a lot of fun and good succeed in the silage slide. ^^
Small unimportant info on the edge:
The small sign for the tractor has been built according to the real model.
The big sign and the additional signs, however, do not exist so and inspired my imagination.